W1219 DC 12V Thermostat Temperature Controller Switch Dual LED Digital Display with NTC Sensor Module for Incubator


Price: [price_with_discount]
(as of [price_update_date] – Details)


[ad_1]
This function is used for temperature calibration. If there is a deviation between the detected temperature and the actual temperature, this function can be used to correct. The corrected value = measured value + correction value. (If you do not control the compressor or do not need delay function, skip this item directly)

High alarm temperature: -49 degrees Celsius up to 110 degrees Celsius
Test input: NTC10K waterproof sensor
Short press button SET: If you start the time setting mode , Nixie tube will blink. You could adjust the time T1 and T2 by button+ and button-. Please wait 5s after your setting date, the module will save the date you have set after 5s
Long press button SET: if you start the parameter setting mode. There are two group parameter for your choice : P0 and P1. You could switch P0 or P1 by short press SET. Under the parameter P0 and P1,you could set the timing mode

[ad_2]